Civil / Environmental Engineers

 
Home | Civil/Environmental engineerin | Earthwork/grading engineering | Erosion control engineering | Soil/Groundwater environmental | Storm/Flood engineering | Surveying & Geomatics | Traffic Engineering | Waste disposal & treatment
  Position:Home>Erosion control engineering>Article Content
stormwater run-off infiltration sand bed
Source:Internet Author:Unknow Pubdate:2010-02-28  
AZCIVIL (Civil/Environme) 25 Nov 09 11:48
I have 60 rural acres in arizona that is to be developed into a RV park. Site is table flat. Parcel is surrounded by two lane roads with no where to route storm run-off, so it will have to be handled on-site.  The town has said they would allow retention ponds, but I don't want to create mosquito breeding ponds.  The new train of thought for storm water control is not just to create impervious conveyance channels to a detention pond, but to create pervious conveyance channels that help the run-off to infiltrate back into the ground as it is going to a detention pond, thereby reducing the volume of run-off needed to be contained.  This development is a P.A.D. requiring 25% of land to be allocated for open space, so I will have areas where I could create grass covered park or play areas.  I thought I could put gentle swales through these areas with sand or porous rock beds to collect the storm run-off and infiltrate back into the ground.  I am concerned of clogging that might happen on the top of the sand or rock bed.  Any thoughts or comments on similar projects? 字串2

cvg (Civil/Environme) 25 Nov 09 12:10
are you in the desert or mountains? Are you handling offsite flow from undeveloped areas? Will your runoff contain sediment - either silt or fine sand? If so, you will have issues with clogging. You may need to prove to the reviewer that you can trap the sediment and that it will not clog the swales. Generally, if you can demonstrate draining in 36 hours by percolation, you can probably be permitted to do what you say. But you might need to install a drywell to make it work. I would recommend a series of shallow retention areas within the swale that fill and then overflow into the next basin which eventually flow into the outfall.

gbam (Civil/Environme) 25 Nov 09 14:58
Have you considered an underground retention system.  These typically allow infiltration w/o the critter issue.  Stormtrap and Land Saver come to mind.  I think both can use infiltration approaches.  But as cvg stated you may need dry wells to meet the requirements.  I was once told that if the water is out of the sunlight mosquitos cannot breed.  I am not sure on this so some research should be conducted maybe consult a bug guy. 字串9

dicksewerrat (Civil/Environme) 5 Dec 09 20:26
ADS also makes an undergound retention system. It can be placed under the roads and parking areas. Richard A. Cornelius, P.E.
WWW.amlinereast.com

(Click:
Previous:Design storm for erosion control   Next:how to estimate the amount of erosion wastes in a road project?
[Add TO Favorites] [TOP] [PRINT] [CLOCE WINDOWS]  
  Hot Article
·rip rap scour protection desig
·Formula for anti-seep collar
·Grout filled fabric revetment
·wire-rock baskets for soil ero
·Rip-Rap/Conduit outlet protect
·Articulated Concrete Block Rev
·Manning roughness coefficients
·Filter fabric specification
·Low Growing Grass?
·Gabion footings
·SEDCAD
·Stabilized Construction Entran
  Related Articles
·how to estimate the amount of
·1
·1
·1
·Pipe end protection
·Storm Water
·Computing Scour Depth for Cree
·Filtrtexx vs. Silt Fence
·Filter Berms and Compost Blank
·Gabions
·Slope/Sheet Erosion
·SEDCAD
Cheap LouisVuitton Bags Civil / Environmental Engineers Structural Engineers Aeronautic Engineers Automotive Engineers Chemical Engineers Geotechnical Engineers Industrial / Manufacturing Engineers Materials Engineers Computer Engineers Agricultural Engineers Mechanical Engineers Petroleum Engineers Bioengineers Military Engineers